Applications

• Developments where foul drainage by gravity is not possible, including:

• Septic Tank Pumpsets

• Domestic Sewage Pumping

• Integral Pumpsets for small sewage treatment plant

• Twin pumping systems for larger plant

• Bespoke systems

Features

• Complete package systems delivered direct to site

• Ready for immediate and simple installation

• Factory built and quality assured

• Maintenance free GRP constructed chambers

• Optional break-down alarm systems available

• All Titan products are manufactured under the quality procedures of BS EN ISO 9002

Design

All standard Titan package pump systems come complete with GRP chamber, pump(s), pre-set automatic level control, non-return valve discharge pipe and fitting to just outside the chamber.

Installation

Installation is quick and economical, the unit requiring only a surround of pea shingle in a dry site or concrete in a wet site.

Maintenance

Titan Package Pump systems are designed for minimum low cost maintenance.

Options

Alarm Systems - for the warning of power or equipment failure.

Bespoke Systems

Titan manufactures pumping chambers up to 1.8 metres diameter and to depths up to 3.5 metres, either on their own or with pumps, guide rails and control equipment installed as per the clients specification.

Advice

The information in this sales literature is by necessity brief. For more detailed technical literature or for applications outside those shown, please contact Titan. We have both internal and field sales staff who will be pleased to assist.

< BACK

PACKAGE PUMP SYSTEMS

Products for the next generation

A Septic Tank Pumpset can be used to disperse settled effluent when a site has a high water table or adverse invert levels.

Installed after the septic tank and pumping settled effluent up to an inspection chamber, drainage to the sub-surface irrigation system then takes place by the normal way.

PUMPED SYSTEMS - TREATED EFFLUENT USING EBARA RIGHT 75 AUTO PUMPS
(calculated using a flow rate of 3.5m^3/hr.)

The performance chart shown assumes pumping takes place through 50mm MDPE pipe which is compatible with the Pumpset outlet fitting supplied. For multiple housing we recommend a twin pumping system.

Biotec Integral Pumpsets

Developed specifically for use with the 4, 6, 12, 18, and P25 Biotec sewage treatment plant, the pumpset is supplied as an integral part of the plant casing. This simplifies installation and obviates the need for drainage connections between the plant and the chamber.

Normally used where a high water table is encountered or drain invert levels are excessive, the system can pump up to an inspection chamber at the head of the sub-surface irrigation system or directly to a stream or water course, subject to Environment Agency consent.

The performance chart is identical to that of the Septic Tank Pumpset and assumes pumping takes place through 50mm MDPE pipe.

If the main sewer is accessible but at a higher level than the domestic foul drain, then a Domestic Sewage Pumpset may be used to pump unsettled sewage directly to the main.

Drainage from the house is by gravity into the chamber which is normally situated conveniently in front of the house. The performance chart shown assumes the pumping takes place through 63mm MDPE pipe which is compatible with the pumpset outlet fitting supplied

PUMPED SYSTEMS - RAW SEWAGE USING EBARA VOX 100 AUTO PUMPS
(Calculated using a flow rate of 8.0m^3/hr.)

Whilst single pump units are suitable for individual houses, it is recommended that twin pumping systems be used for multiple dwellings.

Twin Pumping Systems

For Biotec sewage treatment plant of 40 population equivalent and above, or larger septic tank applications, it is recommended that a twin pumping system be used.

The pumping requirements for these units vary considerably, dependant on such things as the size of a plants, or tank, static and horizontal head and alarm systems required.